Salesforce

Wraptor / A6500 - How to replace the V-block

Printable View
« Go Back

Content

 
Article Number000010124
TitleWraptor / A6500 - How to replace the V-block
Body






Replace the V-Block

 

  1. Press Load Labels on the Setup menu. This shuttles the printer to the “shuttle back” position.
 
  1. Power off and unplug the Wraptor.

WARNING: You must power off and unplug the Wraptor prior to performing any cleaning or maintenance!
 

  1. Open the Wraptor front (clear) door.
 
  1. Rotate the wrapper so that the opening is in the “up” position.

 

  1. Unscrew the retaining post that keeps the wrapper in place.

Retaining post.png
 

  1. Reach behind the wrapper and jog the spring-loaded slide until the Wrapper Foam V-Blockfalls out.

 

  1. Separate the foam V-Block from the stamping plate (part number for stamping plate Y362685).

 

  1. Discard the old foam V-Block and insert a new V-Block into the stamping (part number 60703).

Old Foam V-Block.png
 

  1. Rotate the wrapper so that the opening is in the “down” position.

 

  1. Replace the V-Block/stamping. Insert so the nubs in the stamping are positioned through the holes in the frame of the slider.

New V-Block.png
 

  1. Rotate the wrapper so that the opening is in the “up” position.

 

  1. Replace the retaining post.

 

  1. Close the front cover.
 

Replacement Parts


Related information 

URL NameWraptor-How-to-replace-the-V-block
Powered by