Replace the V-Block
- Press Load Labels on the Setup menu. This shuttles the printer to the “shuttle back” position.
- Power off and unplug the Wraptor.
WARNING: You must power off and unplug the Wraptor prior to performing any cleaning or maintenance!
- Open the Wraptor front (clear) door.
- Rotate the wrapper so that the opening is in the “up” position.
- Unscrew the retaining post that keeps the wrapper in place.

- Reach behind the wrapper and jog the spring-loaded slide until the Wrapper Foam V-Blockfalls out.
- Separate the foam V-Block from the stamping plate (part number for stamping plate Y362685).
- Discard the old foam V-Block and insert a new V-Block into the stamping (part number 60703).

- Rotate the wrapper so that the opening is in the “down” position.
- Replace the V-Block/stamping. Insert so the nubs in the stamping are positioned through the holes in the frame of the slider.

- Rotate the wrapper so that the opening is in the “up” position.
- Replace the retaining post.
- Close the front cover.
Replacement Parts
Related information