NOTE: Do not install the Windows Print Driver for the BBP35 or BBP37 if using Brady Workstation.  The Windows driver should only be installed if using Markware (obsolete, no longer supported) or a 3rd Party software.

Networking the BBP35/37 Printer in Brady Workstation

1. Launch Brady Workstation, go to settings and choose Install Brady Network Printer.



2. Choose language and click Next.



3. Power on and connect your printer via USB, then hit Next. 



4. Select the detected printer model and click Next.



 5. Click Next once the connection has been established.



6. Choose the option for Wired connection, click Next.



7. Name the printer and click Next.



8. Choose DHCP or the option to enter a static IP address. Contact your network administrator if you're not sure which option to choose. 



9. Connect the printer to your network and click Next.



10. Wait for installation to complete.

• Note: If the connection fails, power off the printer and start again from step 1. If it continues to fail contact Brady Technical support. 

11. Click Finish.


See this article if you need to configure the printer to use a static IP: Configure a Static IP for the BBP35/37 in Brady Workstation