Use transfer tape to transfer the label characters onto a surface. Transfer tape is available on Bradyid.com.
Refer to BBP37 - Cut Out Text for further instructions on how to cut out text on a label.
After you print the label, peel away the excess tape from the cut characters at the end of the label so you are peeling against the open end of the letters.
Note: Try to keep the material you are pulling away close to your workstation. This will make it easier to peel off without catching any of the letters.
Use tweezers or your fingers to pick out the center of the letters.
Cut a piece of transfer tape that is slightly longer than the length of the characters and place it on top of the label.
Press firmly around each character.
Carefully remove the transfer tape.
Press the transfer tape onto the surface where you would like it applied. Press firmly over the letters.
Remove the transfer tape at an angle carefully so the characters stay in place.
