Body | The instructions below should be followed for the J2000 to prevent any damage during transit.
It is best to use the original box and foam/cardboard supports. If you do not have the box, contact Brady Technical Support to obtain a box kit and setup a repair authorization: Requesting a Repair Authorization for a Brady Benchtop Printer
Do not use packing peanuts as filler material since the product will settle to the bottom of the box. Bubble wrap, wrapped in alternating directions, would probably work best.
Packing the Printer
- Power off the printer.
- Tape the print carriage holding the ink cartridge so that it stays docked on the far left side of the printer.
- This will prevent the cartridges/print head from drying up outside of the printer during service and allow our service techs to analyze the cartridges if necessary.
- Send your ink cartridge with the printer for service.
|
|
|---|
