Body | BBP11 Original Factory FirmwareThe attached firmware file is the original firmware that was installed on the BBP11 when it launched in the Americas. The only reason you should need to load this file to a BBP11 is if the printer is not working properly and a firmware flash was recommended.
Please follow the instructions listed in this article to reload the firmware: BBP11 - Updating / Reloading the Firmware
IMPORTANT NOTE
If your printer has firmware version 6.65EZ, you have the original firmware that was qualified when the printer was launched in the Americas. There are no known problems with firmware version 6.65EZ. There are only two reasons why you should ever need to upgrade or reload the printer's firmware.
1) If you worked with Brady Tech Support about a problem and the Tech Support representative recommends that you reload the firmware.
2) If the printer is using a custom program which enables it to be used stand-alone AND that program requires specific functionality that is not available in firmware version 6.65EZ. There are two specific programming commands that are gained when upgrading to firmware 6.78EZ. Those commands are TEXTPIXEL and BARCODEPIXEL. If you need assistance with programming the printer for stand-alone use, please contact our Application Engineering team. |
|
|---|
